Responder LE Homepage
  Example: 2007 Honda Odyssey minivan

Our new Responder LE security/remote start system, powered by XPRESSKIT and with an XK400N, will install into this vehicle with only 9 wires, plus the plug-in antenna cable. This includes alarm, remote start, and the following extra-cost install options:
  responder bullet Immobilizer bypass
  responder bullet Full keyless entry with driver’s priority unlocking
  responder bullet Rear hatch release
  responder bullet Control of both power side doors
  responder bullet Monitoring of the rear hatch
  responder bullet Interfacing with the OEM keyless entry remote control
Responder LE Homepage
Design Goals
Design & Form Factor
Technology and Functionality
Installation Simplified
What is the XK400N & Supercode?
A typical vehicle installation
Next Page
  Previous product would require a minimum of 27 wires, plus the plug-in valet
switch, shock sensor, and LED, plus those for the external bypass module itself. Many of those wires were spread out all over the car – in the driver’s door, under the hood, etc.

These 9 wires are all located in the same area.

The installation has been simplified by well over 66% and up to 2 hours of install time has been saved.
  • 9 locations of wire placement using the Responder LE security/remote start system
• 27 locations of wire placement using the previous product system
 

LE Systems:
5202V
Viper 5701 Responder LE Security System with Remote Start
5202P
Python 872 Responder LE Security System with Remote Start
5202X
Clifford 3.3X Responder LE Security System with Remote Start

XK400N Interface:
XK400N
XK400N Plug-in Databus Interface Module
XKEY1
XpressKey1 Transponder Chip for XK400N (1st Gen Chrysler Sentry Key)
XKEY2
XpressKey2 Transponder Chip for XK400N (2nd Gen Chrysler Sentry Key)
XKEY3
XpressKey3 Transponder Chip for XK400N (GM)

 

Click Here For Specifications!